Restoration, reinforcement, repair and protection of concrete and reinforced concrete structures. Waterproofing of buildings, structures and reinforced concrete structures.
The presence of moisture in the flue gases, gas-droplet aggressive chemical compounds, condensate on the inner surface of the lining, frequent starts and stops are only part of the reasons that lead to damage to the chimneys. Types of work: repair of concreting joints, restoration of a protective layer of concrete, installation of reinforcement clips on monolithic trunks, restoration of lining gas tightness, waterproofing of foundations and underground flues, protection of brick pipes with a hydrophobizer.
Production buildings are subject to a whole range of impacts: vibrations from the operating equipment, the load of technological transport, precipitation and heat and humidity transfer. Types of work: repair of structural elements of industrial buildings: restoration of the bearing capacity of ribbed slabs, columns, beams and other reinforced concrete structural elements.
Most w /concrete supports are made in compliance with the principle of maximum concrete economy, which leads to the absence of a protective layer for the reinforcement or it is so insignificant that it does not save from environmental impact. In addition, the impact of electromagnetic fields contributes to the destruction of most of the railway supports. Types of work: repair of concrete, protection of reinforcement and concrete from atmospheric effects. The proven technology makes it possible to protect the reinforcement and restore the protective layers of concrete in a complex. At the same time, the cost of work is several times lower than when replacing supports.
Reinforced concrete cooling tower shells are constantly exposed to water vapor in combination with the temperature difference outside and inside, especially in winter, it intensively destroys concrete. Types of work: restoration of destroyed concrete and exclusion of penetration into the concrete body.