Our specialists will professionally perform work for you on anticorrosive protection of metal and reinforced concrete structures. They will protect technological equipment, storage and transportation facilities from the effects of aggressive chemical products and compounds.
These works will be carried out using modern polymer multicomponent protective coatings based on: epoxy resins, vinyl ester compounds, polyurethane systems, systems based on polyurea, as well as polycarbamide and ebonite components.
The work on corrosion protection is carried out by our specialists using effective and high-performance means of preparing the protected surface, namely its cleaning from rust and old paintwork. To clean the surfaces of metal, concrete, brickwork, we use highly efficient thermoabrasive cleaning units of our own production "Thermax-1" and hydrodynamic cleaning units "HAMMELMANN®". The application of protective coatings is carried out by high-performance airless spraying units manufactured by GRACO® and WIWA®.
Our specialists have mastered the technologies and methods of working with modern protective materials that will reliably protect process tanks in any aggressive environments, from water to aqua regia, at temperatures up to 200 ° C. At the same time, it is possible to protect equipment installed in open areas. At the same time, not only corrosion contamination of high-purity water is excluded, but also uncontrolled migration and contamination of water with organic impurities from the composition of the protective coating. The cost of our coatings inside containers, even with the use of imported materials, is significantly lower than when they are gummed or lined, and the terms of reliable operation are not lower. In addition, our coatings can be subjected to routine repairs, which significantly increases their service life.
Anticorrosive protection of pipe boards, internal surfaces of inlet and outlet chambers of heat exchangers with the use of polymer series "Rokor", "Plastocor" restores tightness, weakens the processes of carbonate scale deposition, which allows to increase the efficiency of heat exchangers and significantly extend their service life.
Metal structures of these industries are subjected to intense exposure to aggressive environments, both inside production buildings and on open industrial sites. In our arsenal of protective equipment there is a wide range of anticorrosive materials that will allow you to choose the most effective system with the required service life. These are materials from such world-famous manufacturers as International Protective Coatings, Henkel, and domestic manufacturers.
When applying anticorrosive coatings to marine and railway vehicles, the key point in assessing the effectiveness of the means, methods and technologies used is the downtime during repair. In turn, a significant part of his time is devoted to the most time-consuming operation of cleaning the metal surface from old coatings, rust and other hard-to-remove deposits. To clean the protected surfaces, our specialists use high-performance thermoabrasive cleaning equipment "Thermax-1". In addition, we are able to work with materials that allow their application, without reducing the quality of the coating, to the surface under extremely unfavorable conditions (humidity up to 99%, temperature near the freezing point).